why the crawler shot blasting machine will appear the poor separation of shot and sand

When the shot material and sand separation effect of the crawler shot blasting machine is not very good, the reasons can be tested from the following two aspects:

1. The position of the adjusting plate is not properly adjusted, so that the pellets cannot be evenly dispersed during operation, so that the parts acting on the objects are only concentrated in a few places, some places have been cleaned very Clean, and the surface can become smoother than before, but some parts have not been cleaned and strengthened.

2. The wind speed of the separator is either too high or too low, resulting in the pellets and sand of the crawler shot blasting machine still bonded together.

, if it is found that the problem caused by the former situation is detected, then the adjustment plate should be repeatedly adjusted and tried until the flow rate is evenly dispersed. In the latter case, the wind speed needs to be adjusted and controlled between 4. and five meters per second. By solving these two problems, the pellets and sand can be well separated.